Requirements

- High school diploma, GED or equivalent required.

- 3 shift rotation (midnights, afternoons, days).

- Production experience preferred.

- Communicate in English (orally and in writing).

Job Duties

- Between racking sessions, must ensure all required empty dunnage is provided to final audit, and all full dunnage is removed in a timely manner.

- Between racking sessions, repack parts as necessary following repack priority schedule.

- Must be able to load and unload pistons from plating racks to required quality and production standards.

- When unloading the rack, start from bottom row up loading only one piston in each hand at a time.

- When loading racks ensure to load only one piston in each hand to prevent handling marks.

- Must be certified as a relief operator for Grinder Operator and Press Operator and follow secure operating procedures (specific to Maple Manufacturing).

- Assist pollution as required (Plater crashes).

- Rotate inventory to ensure First in First out (FIFO) prior to changeover.

- Assist with rack maintenance and repair or change damaged clips as required.

- Understand and adhere to the control and containment procedure for non-conforming or suspect non-conforming product.

- Understand and adhere to the scrap protocol procedure.

- Perform all related housekeeping procedures.

- Ensure Forklift pre-operational checklists done daily.

- Understand and adhere to Escalation Process.

- Follow rack and hanger condition/preventative maintenance process.

- Offload during break coverage is to be performed by utilizing one piston in each hand. There is to be no banging, knocking, or hitting of pistons while offloading.

- Compliance to all safety rules as well as company policies.

- Other duties as assigned by management.

Start-Up Duties





- When requested, assist Line Lead in required duties:

- Waste treatment probe calibration.

- Nickel filter charge.

- Other duties as required by management.

- Hanger Preventative Maintenance:

- Wipe excessive grease form all hangers.

- Check all hangers on the hanger gauge; select the best conditions hangers for use on the line. The remaining hangers are to be sent to maintenance for service.

- Clean hangers to rack contacts on the hangers that are selected to be used in the plater at the four contact areas with emery cloth.

- Consult Line Lead if necessary.

- Rack Preventative Maintenance:

- Clean any grease from the racks, at hanger contact and from coating, to be run per production schedule.

- Clean matching hanger to rack contact point with emery cloth.

- Remove excess “treeing” from contacts, flags, or shields being careful not to further damage rack coating.

- Straighten and adjust any part pins requiring adjustment for proper part contact.

- Consult Line Lead if necessary.

- Set up racking/unracking area as necessary for next production run as per production schedule.

- Clean rust preventative spray unit, take special care when cleaning optic sensors.

- Sweep and mop floors in plating and final audit area.

- Empty garbage.

- Set up final audit area with required packaging as per production schedule.

- Flush eyewash stations and emergency showers until water runs clear at platers and parts washers.

- Clean fire extinguisher covers.

We thank all applicants for their interest, however only those candidates selected for interviews will be contacted.

Pay: $21.78-$23.06 per hour

Benefits

- Casual dress

- On-site parking

Education

- Secondary School (required)

Licence/Certification

- Grade 12 Math (preferred)

Work Location: In person

📌 General Labour (Plater Racker) (Beamsville)
🏢 Niagara Piston
📍 Beamsville